Spectra-precision FAST Survey Reference Manual Instrukcja Użytkownika Pobierz pdf (Strona 220)

100

101

p218

After completing a conversion, you may enter a point ID and press

Save

to save the coordinates to the current job.

You can also change the type of transformation or zone system used. If you don’t want NAD 83 (primarily used in

the U.S.) you can go to

Job Settings

GPS

and change the Transformation type. For example, you could change

the Transformation to UTM or NTF-France. Then, back in Calculator, your coordinate to Lat/Long calculation

would be based on the configured transformation. Note that when converting Grid System Coordinates to WGS84

coordinates and going WGS84 to Grid, the geoid separate file (if any) is applied to the calculation.



Az-Br:

This does a straight, simple calculation converting azimuths to bearings. A prime example, shown below,

would be converting an azimuth of 119.2547.

Other Calculations

There are two types of calculations that can be performed from the OTHER tab. Click the large, square icons to go to

the Triangle or Curve calculator.

Triangle Calculator

The figure below shows the Triangle calculator. The top of the dialog box indicates the mode of calculation. To change

the mode, simply use the pull-down and to selec the desired mode.



Side-Side-Side



Angle-Side-Angle



Side-Angle-Angle



Side-Angle-Side



Side-Side-Angle

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 397 398

Komentarze do niniejszej Instrukcji

Brak uwag

Spectra-precision FAST Survey Reference Manual Instrukcja Użytkownika Strona 220

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Spectra-precision FAST Survey Reference Manual