
Trouble Shooting
79
• Tap to configure the base station. Since the Localization
adjustment is already solved, you will not be prompted to
solve the projection again.
10. Check points and add control point.
• Go to Control Points
. Select point
2
and tap .
Since you have not yet set the rover, tap at the
prompt, then retap . The results should be
perfect.
• Add Control Point
2
. Deselect the
H
/
V
check when you are
collecting it. This point will be used only if necessary.
11. Move the base to a point in the coordinate file not measured with
GPS.
• Go to Base Setup
, select point
4
and tap . Since this
point does not have geodetic coordinates, you are prompted to
compute coordinates from the known (N,E,Elev) and the
latest projection solution. Tap
Note: This action is equivalent to the TDS “Move Base” routine in the
DOS software.
• The geodetic coordinates for point
4
are computed. Tap
to configure the receiver.
12. Set the Rover.
13. Check points.
• Go to Control Points
. Select point 2 and tap Check Point.
The results should be perfect.
Komentarze do niniejszej Instrukcji